Supermicro X13SRA-TF - Page 112

Super X13SRA-TF User's Manual
112
Terminal Type EMS
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits Per Second EMS
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 57600, and 115200 (bits per second).
Flow Control EMS
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xo󰀨.
The following information is displayed:
Data Bits EMS / Parity EMS / Stop Bits EMS
Network Conguration
Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unied Extensible
Firmware Interface (UEFI) for network stack support. The options are Disabled and Enabled.
IPv4 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 PXE boot support. If this feature is disabled, it will not create
the IPv4 PXE boot option. The options are Disabled and Enabled.
IPv4 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 HTTP boot support. If this feature is disabled, it will not create
the IPv4 HTTP boot option. The options are Disabled and Enabled.
IPv6 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 PXE boot support. If this feature is disabled, it will not create
the IPv6 PXE boot option. The options are Disabled and Enabled.
IPv6 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 HTTP boot support. If this feature is disabled, it will not create
the IPv6 HTTP boot option. The options are Disabled and Enabled.