SUPER 370SBA/370SBM/370SLA/370SLM User’s Manual
5-20
Parallel Port DMA Channel
This option is only available if the setting of the parallel port mode option is
ECP
. The settings are
0
,
1
,
2
,
3
,
5
,
6
or
7
.
On-Board IDE
This option specifies the onboard IDE controller channels to be used. The
settings are
Disabled, Primary
,
Secondary
or
Both
.
5-2 Security Setup
Supervisor/User
The system can be configured so that all users must enter a password every
time the system boots or when the WINBIOS setup is executed. You can set
either a Supervisor password or a User password. If you do not want to use
a password, just press <Enter> when the password prompt appears.
The password check option is enabled in the Advanced Setup by choosing
either
Always
or
Setup
. The password is stored in CMOS RAM. You can
enter a password by typing the password on the keyboard, selecting each
letter via the mouse, or selecting each letter via the pen stylus. Pen access
must be customized for each specific hardware platform.
When you select Supervisor or User, AMIBIOS prompts for a password. You
must set the Supervisor password before you can set the User password.
Enter a 1-6 character password. The password does not appear on the screen
when typed. Retype the new password as prompted and press <Enter>.
Make sure you write it down. If you forget it, you must drain CMOS RAM and
reconfigure.
To Next Page
Loading...
Need help?
General
