Chapter 5: Running Setup
5-3
Date and Time Configuration
Select the Standard option. Select the
Date/Time
icon. The current values
for each category are displayed. Enter new values through the keyboard.
Floppy A
Floppy B
Choose the Floppy Drive A or B icon to specify the floppy drive type. The
settings are
Not Installed,
360 KB 5¼ inch
,
1.2 MB 5¼ inch
,
720 KB 3½
inch
,
1.44 MB 3½ inch
or
2.88 MB 3½ inch
.
Note: The Optimal and Fail-
Safe settings for Floppy Drive A are 1.44 MB 3 1/2 inch and for Floppy
Drive B are Not Installed
.
Advanced Setup
Quick Boot
The Settings are
Disabled
or
Enabled
. Set to
Enabled
to permit AMIBIOS
to boot quickly when the computer is powered on. This option replaces the
old Above 1 MB Memory Test Advanced Setup option. The settings are:
Setting Description
Disabled
AMIBIOS tests all system memory. AMIBIOS waits
up to 40 seconds for a READY signal from the IDE
hard disk drive. AMIBIOS waits for .5 seconds after
sending a RESET signal to the IDE drive to allow the
IDE drive time to get ready again. AMIBIOS checks
for a <Del> key press and runs AMIBIOS Setup if the
key has been pressed.
Enabled
AMIBIOS does not test system memory above 1 MB
AMIBIOS does not wait up to 40 seconds for a READY
signal from the IDE hard disk drive. If a READY signal
is not received immediately from the IDE drive, AMIBIOS
does not configure that drive. AMIBIOS does not wait
for .5 seconds after sending a RESET signal to the IDE
drive to allow the IDE drive time to get ready again. In
Enabled,
keyboard will be bypassed.
Note: You cannot run AMIBIOS Setup at system boot, because there is
no delay for the Hit <Del> to run Setup message.
To Next Page
Loading...
Need help?
General
