4-20
X8DA3/X8DAi User’s Manual
IPMI Confi guration (Available when an IPMI Card is
installed on the board.)
Intelligent Platform Management Interface (IPMI) is used for system health monitor-
ing and system management.
Status of BMC
This feature displays the status of the BMC controller which manages the interface
between system software and hardware.
IPMI Firmware Revision
This feature displays the fi rmware revision of current IPMI platform.
View BMC System Event Log
This feature displays the BMC System Event Log (SEL). To view an event, select
an Entry Number and pressing <Enter>.
SEL Entry Number
•
SEL Record ID•
SEL Record Type•
Event Timestamp•
Generator ID•
Event Message Format User•
Event Sensor Type•
Event Sensor Number•
Event Dir Type•
Event Data•
Clear BMC System Event Log
Clear BMC System Log
Select OK and press the <Enter> key to clear the BMC system log. Select Cancel
to keep the BMC System log. The options are OK and Cancel.
Caution: Make sure that you no longer need data stored in the log before
clearing the BMC Event Log.
To Next Page
Loading...
Need help?
General
