Need help?Do you have a question about the Supertech CS-164 and is the answer not in the manual?
FM Tuner| frequency range | 87.5-108.0 MHz |
|---|---|
| usable sensitivity | 2 V at s/n 30 dB |
| intermediate frequency | 10.7 MHz |
MW Tuner| frequency range | 520-1620 KHz |
|---|---|
| usable sensitivity | 40 dB at S/N 20 dB |
| intermediate frequency | 455 KHz |
CD/MP3 Player Section| signal to noise ratio | >60 dB |
|---|---|
| frequency response | 20 Hz-18 KHz |
Reamplified Lineout| output | 600 mV (MAX) |
|---|---|
| impedance | 10 Kohm |
General| power supply voltage | DC 13.2 Volts Negative Ground |
|---|---|
| maximum current consumption | 6 A |
| maximum output power | 40 W X4CH |
Features a detachable front panel and electronic controls for operation.
Supports CD/MP3 playback and FM/MW stereo radio reception.
Includes RDS, Traffic Announcement (TA), and Alternative Frequencies (AF).
Explains warning symbols like exclamation points and lightning flashes.
Advises against removing covers and warns about laser radiation exposure.
Instructs to avoid moisture, ensure ventilation, and keep away from direct sunlight.
Diagram illustrating the arrangement of buttons and displays on the front panel.
Identifies key components like the CD slot, reset button, and card jacks.
Details the functions of the Power, Select, and Volume up/down buttons.
Explains the operation of the tuning knob, band, and mode selection buttons.
Describes functions like AF, TA, DSP, Intro, Repeat, and Random playback.
Covers SD/MMC, USB inputs and the reset button functionality.
Advises on choosing a suitable location to avoid heat, dust, and vibration.
Provides guidance on adjusting the mounting angle and a dashboard installation example.
Notes the importance of keeping the release key for future removal.
Step-by-step instructions for detaching the front panel from the unit.
Instructions on how to correctly reattach the front panel to the unit.
Offers advice on carrying and handling the front panel, including using the case.
Details the pin assignments for Connector A and its functions.
Details the pin assignments for Connector B for speaker outputs.
Highlights the critical connection of the ignition power (7) to prevent battery drain.
Explains how to check power connections and replace a blown fuse.
Warns against using fuses with higher amperage to prevent damage.
Describes how to turn the unit on/off and adjust the volume.
Explains using the SEL button to select functions and activate DSP mode.
Details how to activate loudness to boost bass and treble response.
Covers the operation of ESP mode and settings for the beep sound.
Instructions for switching between Stereo and Mono for FM reception.
Provides information on the Radio Data System and its benefits.
Explains the functionality of Alternative Frequencies (AF) and Traffic Announcements (TA).
How to use the tuning knob to select radio stations.
Using the DSP button to cycle display modes and set the clock.
Operation of MODE, BAND, and track SKIP buttons.
Information shown on the LCD display and the panel release button function.
Procedures for inserting CDs into the slot and ejecting them.
Usage of PAUSE, INTRO, REPEAT, and RANDOM buttons.
How to use the 10 TRACK DOWN/UP buttons for quick track selection.
Details when and how to use the reset button for initial setup or troubleshooting.
Provides technical details for FM/MW tuners and the CD/MP3 player.
Lists general specifications like power voltage, impedance, and output power.
Information on responsible disposal of the product according to regulations.
To Next Page