Supertech CS-164 User Manual

If the volume level was under the threshold point, it will be
raised to the threshold point.
When TA station is received, TA segment is turned on in LCD
display.
6. TUNING KNOB
In radio mode, rotate the manual - tuning knob to select station
you desired.
7. DISPLAY (DSP)
Selects radio frequency ,clock display and ON PTY
To set the clock:
(1). Wit h clock display selected, hold down the "DISP" button
until clock display starts flashing.
(2). Press VOL+ and VOL- to change minutes and hours.
(3). Press "DISP" button to start the clock.
When this key is pressed it is operated as the conversion of
each display mode as follow.
1) Incase of receiving RDS station
TUNER MODE
PS --- TA --- FREQ --- CT
CD/MP3 PLAYER MODE
CDP --- PS --- TA --- FREQ --- CT
2) In case of receiving NON RDS station
RADIO MODE
CLOCK --- FREQ --- NO PTY
CD/MP3 PLAYER MODE
CDP --- FREQ --- CT --- N O PTY
Each display time is several seconds, and come back to 1 St
position after several seconds.
CT=clock time FREQ=frequency

Supertech CS-164 Specifications

FM Tuner

frequency range	87.5-108.0 MHz
usable sensitivity	2 V at s/n 30 dB
intermediate frequency	10.7 MHz

MW Tuner

frequency range	520-1620 KHz
usable sensitivity	40 dB at S/N 20 dB
intermediate frequency	455 KHz

CD/MP3 Player Section

signal to noise ratio	>60 dB
frequency response	20 Hz-18 KHz

Reamplified Lineout

output	600 mV (MAX)
impedance	10 Kohm

General

power supply voltage	DC 13.2 Volts Negative Ground
maximum current consumption	6 A
maximum output power	40 W X4CH