Why does my SureCall N-Range signal booster have no power?
If your SureCall Extender signal booster has no power, first check that the Power LED is ON. Try connecting the power supply to a different power source to rule out an issue with the original outlet. Make sure the power source is working and the fuse is intact.
Details on using adhesive tape for secure mounting on non-metal vehicle surfaces.
Steps to verify power supply, connections, and contact support if issues persist.
Advice on verifying cable connections and using call quality to confirm signal.
Details on FCC rules for fixed, mobile, and portable stations in specific frequency bands.
Register device with provider; comply with Canadian ISED rules; use approved parts.
Warning about potential inaccuracies or unavailability of E911 location information.
Disclaimer of implied warranties and limits on liability for damages.
General| Uplink Frequency Range | 698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 MHz |
|---|---|
| Downlink Frequency Range | 728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 MHz |
| Impedance | 50 Ohm |
| Type | Cellular Signal Booster |
| VSWR | ≤2.0 |
| RF Connectors | SMA Female |
| Frequency Bands | 700 MHz, 800 MHz, 1900 MHz |
| Indoor Antenna | Patch |
To Next Page
