Sutron Corporation X-Link Operations & Maintenance Manual, Rev 1.63 5/24/2016 pg. 42
4.8.2. LinkComm Versions and Diagnostics
The bottom two text areas on the Diagnostics tab display information about
LinkComm.
The LinkComm Data Usage section displays the total byte counts between
LinkComm and X-Link for the current session. The LinkComm Diagnostics section
displays LinkComm’s version information.
Press the Refresh… button to update this data to the latest. Press the Save to
file… button to save all diagnostic text data to an external file.
4.8.3. Terminal
LinkComm features a built in terminal monitor program. All communications
between LinkComm and X-Link uses the command line interface. The Terminal
window can be used to view a history of command traffic, and can be used to
access the command line interface directly.
To see the details of the communication between LinkComm and X-Link, bring up
the terminal window via the Terminal button on the Diagnostic tab.
You may type into the terminal window. Data typed will be sent to X-Link. Any
replies from X-Link will be shown in the Terminal window.
To Next Page