8.5.2. Wireless transmitter battery replacement
NOTE
It is advisable to contact an authorized Suunto representative for
transmitter battery replacement. It is imperative that the change
is made in a proper manner to avoid any leakage of water into
the transmitter.
CAUTION
Defects caused by improper battery installation are not covered
by the warranty.
Battery kit
The transmitter battery kit includes a 3.0 V CR ½ AA lithium cell battery and a lubricated
O-ring. When handling the battery, do not make contact with both of the poles at the
same time. Do not touch the metal surfaces of the battery with your bare fingers.
Required tools
•
A Phillips-head screwdriver
•
Soft cloth for cleaning
Transmitter battery replacement
To change the transmitter battery, follow the procedure below:
1.
Remove the transmitter from the regulator HP port.
2.
Unscrew and remove the four Phillips screws on the back of the transmitter.
3.
Pull off the transmitter cover.
4.
Carefully remove the o-ring. Be careful not to damage the sealing surfaces.
96
To Next Page
Loading...
