8.2 Using compass
When you are in the COMPASS mode, you see two moving
segments on the rim of the display. These point towards North. The
hairline at 12 o’clock shows your heading and functions as a
compass direction arrow. The numerical value of your heading is
shown in the center of the display.
In COMPASS mode you can access the following views with [View]:
•
Time: shows the current time
•
Cardinals: shows the current heading in cardinal directions
•
Bearing tracking: shows the direction between the heading and
the set bearing
The compass will switch itself to power saving mode after a minute
if no buttons are pressed. Reactivate it with [Start Stop].
You can use the compass in two ways: you can use the bezel or the
bearing tracking.
44
To Next Page
Loading...
