39
SYSTEM ACTIVATION
If equipped with multi-function gauge:
When the total operating hours have reached
the preprogrammed hours, the “Change Oil” is
displayed on screen, and the buzzer sounds.
This indication will repeat until you cancel the
system activation.
If equipped with monitor-tachometer:
When the total operating hours have reached
the preprogrammed hours, the OIL lamp will
flash. If the engine is not running, the buzzer
will begin a series of double beeps additionally.
This indication will repeat until you cancel the
system activation.
CANCELLATION
NOTE:
If equipped with Keyless Start System in case
of Dual Engine:
Cancellation of system activation may be
achieved by operating either one of the engine
switch.
1. If equipped with Keyless Start System:
Press and hold the engine switch 1 for more
than two seconds to turn on the power.
If not equipped with Keyless Start System:
Turn the ignition key to the “ON” position.
2. Pull out the emergency stop switch lock
plate 2.
3. Pull up the emergency stop switch knob 3
three times in 10 seconds. A short beep will
be heard if the cancellation is successfully
finished.
4. If equipped with Keyless Start System:
Press and hold the engine switch 1 for more
than two seconds to turn off the power.
NOTE:
The power can also be turned off by pressing
the lock button on the keyless fob.
OFF
ON
START
To Next Page
Loading...
