50
NOTE:
If the emergency stop switch lock plate is not in
position, the starter motor cannot operate.
If equipped with Keyless Start System:
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. (1)Confirm that the keyless fob is in commu-
nication ON mode (Refer to the “Switch-
ing the Communication mode of the
keyless fob” section.) Check that the key-
less fob is within communication range
with the keyless control unit.
(2)Quickly press the engine switch to set
Keyless Start System to ON state (buzzer
sounds once) and automatically start
engine.
NOTE:
The communication range is a distance of 1 m
(40 in) between the keyless fob and the keyless
control unit.
If the Keyless Start System fails to turn ON, the
buzzer emits one (1) long sound and three (3)
short sounds.
In this case, repeat the procedure again.
NOTE:
The continuous operating time of the starter
motor is set at four seconds.
When this time is exceeded, the starter motor
will automatically stop.
If the motor stops, wait about ten seconds for
the motor to cool down and try again.
3. Warm up the engine for about 5 minutes.
If not equipped with Keyless Start System:
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
NOTICE
Operating the engine at high RPM or “wide
open throttle” immediately after starting the
engine without allowing the engine to warm
up may cause engine failure.
Always allow the engine to warm up suffi-
ciently before operating it at high speeds.
To Next Page
Loading...
