25
NOTE:
There is a spare plastic lock plate for temporary
use only. Remove it from the cord and place in
a safe place on the boat. However, the original
cord and lock plate should be replaced as soon
as possible.
STARTING THE ENGINE
NOTE:
If the emergency stop switch lock plate is not in
position, the starter motor cannot operate.
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
WARNING
• Never start the engine or let it run
indoors or where there is little or no
ventilation. Exhaust gas contains car-
bon monoxide, a gas that is colorless
and odorless and can cause death or
severe injury.
• Before starting the engine, make sure
that you have enough fuel and oil to
complete your intended trip.
2. Side mount type:
Make sure the warm-up lever is in the fully
closed position.
3. Turn the ignition key to the “ON” position,
then observe the monitor-tachometer indica-
tion. If nothing abnormal is indicated, then
turn the key to the “START” position to start
the engine.
CAUTION
Never move the ignition key to “START”
position for more than 5 seconds, or the
starter system could be damaged.
CAUTION
If the OIL lamp remains lit while operat-
ing, check the engine oil level after stop-
ping the engine.
To Next Page
Loading...
