6-26
9. Replace the gasket with a new
one. Reinstall the drain plug and
gasket. Tighten the plug securely
with a torque wrench. Pour 2750
ml (2.9/2.4 US/Imp. qt) of new
engine oil through the filler hole
and install the filler cap. Be sure to
always use the specified engine
oil described in the FUEL,
ENGINE OIL AND COOLANT
RECOMMENDATIONS section.
Drain plug tightening torque:
21 N·m (2.1 kgf-m, 15.0 lbf-ft)
NOTE: About 2400 ml (2.5/2.1 US/
lmp. qt) of oil will be required when
changing oil only.
10. Start the engine (while the motor-
cycle is outside on level ground)
and allow it to idle for three min-
utes.
11. Turn the engine off and wait
approximately three minutes.
Recheck the oil level on the
engine oil inspection window while
holding the motorcycle vertically. If
it is lower than the “L” mark, add
oil until it reaches the “F” mark.
Inspect the area around the drain
plug and oil filter for leaks.
NOTE: If you do not have a proper oil
filter wrench, have your Suzuki dealer
perform this service.
NOTICE
Engine damage may occur if you
use oil that does not meet
Suzuki’s specifications.
Be sure to use the oil specified in
the FUEL, ENGINE OIL AND
COOLANT RECOMMENDATIONS
section.
To Next Page
Loading...
