Suzuki GS500E - GS500 K3 (03-Model) Signal Generator

19-20 GS500K3 (’03-MODEL)
Inspect the No.2 ignition coil primary peak voltage in the same
manner of No. 1 ignition coil inspection.
No. 2 ignition coil: B/Y terminal – Ground
(

+ Probe) (

- Probe)
B/Y: Black with Yellow tracer
NOTE:
Do not disconnect the ignition coil primary wire.
) Tester knob indication: Voltage (*)
+ Ignition coil primary peak voltage: More than 100 V
If they are lower than the specified values, inspect the ignition
coil, signal generator and ignitor.
SIGNAL GENERATOR
NOTE:
At above condition, the right cylinder is at the Top Dead Center (TDC). When checking the tappet clearance
and assembling the camshafts, the signal generator rotor must be at this position.