3-22 ENGINE
GENERATOR COVER
• Remove the generator cover 1.
• Remove the dowel pins and gasket.
GENERATOR ROTOR
• Hold the generator rotor with the special tool.
09930-44520: Rotor holder
• Remove the generator rotor bolt.
• Install a bolt A of suitable size to the left end of crankshaft.
SUITABLE BOLT A [M12, length: 28 – 38 mm]
• Remove the generator rotor with the special tool.
09930-34980: Rotor remover
WATER PUMP
• Remove the water hose 1 and water inlet cover 2.
• Remove the water pump 3.
WATER PUMP SERVICING (7-11)
28 – 38 mm
To Next Page
Loading...
