7-48
REAR TURN SIGNAL LIGHT
To replace the turn signal light
bulb, follow these directions.
1. Remove the screw 1.
2. Turn the socket counterclock-
wise and remove it.
3. Push in on the bulb, turn it to
the left, and pull it out.
4. To fit the replacement bulb,
push it in and twist it to the
right while pushing.
CAUTION
Overtightening the screws
when reinstalling the lens may
cause the lens to crack.
Tighten the lens screws only
until they are snug.
PartShark.com
877-999-5686
To Next Page
Loading...
