3-11
Light Brightness Selection
Push the SEL button F and the
brightness indicator comes on in
odometer/trip meter area. Push-
ing the ADJ button H will change
light brightness in 5 steps. The
brightness indicator indicates
brightness from “ ” (min) to
“” (max).
Preset rpm Selection
Push the SEL button F from the
light brightness selection mode.
Push the ADJ button H to select
preset a rpm. Push the ADJ but-
ton H to change the preset rpm
from 4000 r/min to 8000 r/min in
steps of 500 r/min and from 8000
r/min to 11500 r/min in steps of
250 r/min.
Push the SEL button F to fix the
selected setting. The engine rpm
indicator system holds the
selected settings when the igni-
tion switch is turned off. The sys-
tem settings will remain when the
ignition switch is turned on again.
Odometer/Trip Meter/
Fuel Injection System
Indicator “FI” G
The indicator displays odometer/
trip meter under normal condition.
When the ignition switch is turned
to the “ON” position, the test pat-
tern shown below is displayed.
The display is memorized when
the ignition switch is turned off
and the memorized display
appears when the ignition switch
is turned on again.
To change the display, push the
SEL button F. The display
changes in the order below.
PartShark.com
877-999-5686
To Next Page
Loading...
