2-11
Dimmer Switch 3
Use the dimmer switch to select the
high or low headlight beam when the
ignition switch is in the “” position.
When you move the dimmer switch to
the “HI” position, the high beam will
light and the high beam indicator light
will come on. When you move the
dimmer switch to the “LO” position,
the low beam will light.
Engine Stop Switch 4
“OFF” position
The ignition circuit is off and the
engine cannot start or run.
“RUN” position
The ignition circuit is on and the
engine can run.
Electric Starter Button 5
Use this button to turn the starter
motor. Before starting the engine, turn
the ignition switch and engine stop
switch to the “ON” position. Squeeze
the clutch lever and push the electric
starter button to start the engine.
NOTE: This vehicle is equipped with
interlock switches for the ignition cir-
cuit and the starter circuit. The engine
can only be started if the clutch is dis-
engaged.
CAUTION
Engaging the starter motor for
longer than five seconds at a time
can damage the ATV.
The starter motor and wiring har-
ness may overheat.
If the engine does not start after
several attempts, check the fuel
supply and ignition system. Refer
to the TROUBLESHOOTING sec-
tion in this manual.
To Next Page
Loading...
