3-15
To turn the ATV, use the following
technique:
• Turn the handlebars in the direc-
tion of the turn.
• Shift body weight slightly forward
and support your weight on the
outer footrest. This will reduce the
load on the inside rear wheel,
reducing its traction.
• Lean upper body into the turn.
At HIGHER SPEEDS:
Use the same technique that you use
for turning at low speeds, but lean far-
ther into the turn. Natural turning
forces (which can push the vehicle to
the outside of the turn) increase as
speed increases. This means you
must lean your upper body farther into
the turn as you go faster. This pre-
vents the vehicle from tipping over to
the outside of the turn. Remember,
though, to keep your weight sup-
ported on the outer footrest.
SKIDDING OR SLIDING
You may experience skidding or slid-
ing when you are not braking. You
may be able to overcome it by using
the techniques listed below.
If your front wheel skids:
Gain front wheel traction by reducing
the throttle opening and leaning your
body weight slightly forward.
If your rear wheel skids:
If space permits, steer in the direction
of the skid. Shift your body weight
away from the skid slightly. Avoid
using the throttle or brakes until you
regain directional control of the vehi-
cle.
WARNING
Skidding or sliding improperly can
be hazardous.
You may lose control of your ATV,
or regain traction unexpectedly,
which may cause the ATV to over-
turn.
• Learn to safely control skidding
or sliding by practicing at low
speeds and on level, smooth
terrain.
• On extremely slippery surfaces,
such as ice, go slowly and be
very cautious in order to reduce
the chance of skidding or slid-
ing out of control.
To Next Page
Loading...
