2-18
REAR SUSPENSION
Spring Pre-load Adjustment
This adjustment can be performed by
changing the adjuster ring position.
However, Suzuki recommends that
this adjustment be done by your
authorized Suzuki dealer, since a
special tool is needed for this job.
Damping Force Adjustment
The rebound and compression damp-
ing force can be individually adjusted
by turning the respective adjusters.
The rebound damping force adjuster
1 is located at the bottom of the rear
suspension. The high-speed and low-
speed compression damping force
adjusters 2, 3 are located at the left
side of the rear suspension.
To adjust the damping force, set the
adjuster to the standard setting first
and then adjust the adjuster to the
desired position.
To set the rebound damping force,
turn the adjuster clockwise until it
stops and then turn it counterclock-
wise. As you turn the adjuster, you will
notice clicks. Count the number of
clicks from the fully turned-in position.
The standard rebound damping force
setting is 7 clicks.
To Next Page
Loading...
