5-12
3. Remove the oil tank filler cap 2.
The engine oil dipstick comes out
together with the oil filler cap.
4. Wipe the oil from the dipstick
using a clean rag.
5. Reinsert the dipstick until the
threads touch filler neck, but do
not screw the cap in.
6. Draw out the dipstick and check
the oil level. The level found on the
dipstick should be between “L”
(Low) and “F” (Full) lines. If the oil
level is below the “L” line, add
fresh oil into the filler hole until the
oil level reaches the “F” line.
ENGINE OIL AND FILTER CHANGE
The oil should always be changed
when the engine is warm so that the
oil will drain thoroughly from the
engine. The procedure is as follows:
1. Place the vehicle on level ground.
2. Remove the oil tank filler cap.
3. Remove the under cover.
LF
CAUTION
Operating the vehicle with an
incorrect amount of oil can dam-
age your ATV.
Too little or too much oil can dam-
age your engine.
Place the ATV on level ground.
Check the oil level with the engine
oil dipstick before each use of the
vehicle. Be sure the engine oil
level is always above the “L” (low)
line and not higher than the “F”
(full) line.
To Next Page
Loading...
