5-15
11. Pour approximately 1300 ml (1.4/
1.1 US/Imp qt) of fresh oil into the
engine oil tank.
NOTE: Approximately 1200 ml (1.3/
1.1 US/Imp qt) of oil will be required
when changing oil only without
replacing the oil filter.
12. Pour approximately 400 ml (0.4/
0.4 US/Imp qt) of fresh oil into the
crankcase.
NOTE: Approximately 400 ml (0.4/0.4
US/Imp. qt) of oil will be required
when changing oil only without
replacing the oil filter.
13. Start the engine and allow it idle
for a few minutes. Check to see
that no oil is leaking from the oil fil-
ter cover.
14. Check the oil level according to
Engine Oil Level Check proce-
dure.
CAUTION
Failure to use the correct oil can
damage your ATV.
Engine damage may occur if you
use oil that does not meet
Suzuki’s specifications.
Be sure to use the oil specified in
the FUEL, OIL AND ENGINE
COOLANT RECOMMENDATION
section.
To Next Page
Loading...
