Suzuki VZR1800 2007 User Manual

FUEL SYSTEM AND THROTTLE BODY 6-23
FUEL INJECTOR INSTALLATION
• Apply thin coat of the engine oil to new injector cushion seals
and O-rings. (!6-20)
• Install the injector by pushing it straight to the throttle body.
Never turn the injector while pushing it. (! 6-20)
THROTTLE VALVE SYNCHRONIZATION
Check and adjust the throttle valve synchronization among two
cylinders.
Step 1
• Remove the fuel tank. (!6-3)
• Remove the ISC valve. (!6-18)
• Connect the ISC valve coupler 1 and hoses 2.
• Connect the special tool (Mode select switch) to the dealer
mode coupler. (!5-18)
• Disconnect the vacuum hoses 3 from each throttle body.
• Connect the vacuum tester hoses 4 to each vacuum nipple
on the throttle body.
#1 #2
#1 #2

Suzuki VZR1800 2007 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, 54-degree V-twin
Transmission	5-speed
Front Tire	130/70R18M/C 63H
Overall Height	1185 mm
Seat Height	705 mm
Torque	160 Nm @ 3200 rpm
Ground Clearance	140mm
Overall Length	2485 mm (97.8 in)
Power	125 hp (93 kW) @ 6200 rpm