©2018 SwellPro All Rights Reserved
37
Take Note: The motors can be stopped for any emergency. Stopping the motors whilst
airborne may cause the drone to crash, and should only be carried out in emergencies
(for example: there is a risk that the drone may hit people, or crowds), and stopping the
motors will minimize any potential damage.
1. Place the drone on a flat open surface or on the surface of the water.
2. Power on the remote control, followed by the drone.
3. Wait for the FPV screen to display the camera's live video, and the OSD data display is normal, and there are
more than 9 GPS satellites. The drone enters into a safe flight status, you can unlock the motors and fly.
4. Push the THROTTLE joystick up slowly, allowing the drone to take off smoothly.
5. When you need to descend, slowly pull down the throttle joystick, whilst flying the drone, allowing the
drone to descend, and land on a flat surface, or on the water.
6. After safely landing, keep the throttle down in its lowest position for at least 5 seconds until the motors
have stopped.
7. First, power down the drone, followed but it’s remote control.
For more use information on flight knowledge, please watch the tutorial videos.
Flight safety awareness is very important for you, the people and the environment around you.
Be sure to read the disclaimer, and the safe operating instructions carefully.
Basic Flight Operation
Basic Flight Steps
1. Always check everything prior to flying.
2. Preferably, try to take photos or videos while flying in GPS mode.
3. Try to choose clear, less windy weather.
4. Set up the camera parameters to match and support your filming requirements.
5. Before your intended flight, familiarize yourself with the environment, this helps for efficient flying and
optimum photography.
6. While flying, apply the minimum of movement on the joysticks, this will allow for smooth video and good
quality still pictures.
Aerial tips and tricks
To lock the motors: Pull both the left and the right joysticks outwards
to the lower sides at an angle of 45 degrees to stop , and lock the
motors.
Stopping (locking) the Motors
To Next Page
Loading...
