111
MOTORHOME CARE
Step 3: Standing in the middle of the bed unfold
the seat base..
Step 4: Standing in the middle of the bed pull
upward the sliding section of the frame..
Step 5: Moving to the end of the bed lower the
extended bed frame over the off side seat base.
Step 6: Lowering the bed fame, ensure hooks
locate into the off side bed base top
Step 7: Once the frame is located Turn the base
cushions over. This creates a flat bed base.
Step 8: The back rests are positioned in the
middle of the bed. With the backs surface aiming
upwards
CAUTION: Care should be taken not to trap
fingers in the folding parts of the bed.
To Next Page
Loading...
