45
In addition, to clean a rod type sensor:
WARNING: Only use food safe plastic mesh
scourers, which are suitable for domestic use,
for cleaning the sensor studs.
1. Remove the sensor from the tank
2. Check the studs for build up of contamination
3. Use clean soapy water
4. Place scourer in water to dampen
5. Apply scourer to the sensor probes with
limited pressure
6. Rub sensor studs removing contamination
7. Swill sensor studs with fresh clean water
8. Replace sensor into tank.
7.9 The External Shower Point
The external shower point will be supplied with
a separate shower head and hose assembly.
To connect the shower hose, simply slide the lid
on the housing up and remove the blank cap by
pushing the blue Hozelock fitting forward and
pulling the blank out. Screw the male Hozelock
fitting (supplied) on to the end of the hose screw
thread and then push into the female fitting
inside the housing.
To remove, push the blue Hozelock fitting
forward and pull the male fitting on the hose
from the housing. Replace the blank cap.
CONNECTING SERVICES
To Next Page
Loading...
