Fitted Equipment
- open the windows and leave the room;
- contact the Customer Service
department of Thetford.
• You suspect a leak in the cooling system:
- switch off the refrigerator;
- extinguish any naked flames;
- provide sufficient ventilation;
- contact the Customer Service
department of Thetford.
ABOUT YOUR REFRIGERATOR
Your refrigerator has a cold space and a
freezer compartment. After starting up the
refrigerator, allow it to cool for at least eight
hours before placing any food in it.
Cold space
The cooling fins are located on the inside of
your refrigerator. The absorption system uses
the cooling fins to withdraw heat from the
refrigerator. Therefore, never place plastic or
paper over the cooling fins. Air must be able
to circulate freely through the refrigerator so
that heat can be extracted.
Important! Do not cover the cooling fins at
the back of the refrigerator with plastic or
paper. The refrigerator cools optimally when
air is allowed to move freely through the
refrigerator.
• To limit frosting on the cooling fins:
- always cover liquid foods before placing
them in the refrigerator;
- always let hot food cool before placing
it in the refrigerator;
- never keep the refrigerator open longer
than necessary.
Fitting racks
Inside your refrigerator there are two or three
storage racks. You can adjust the racks to a
convenient height by means of a simple click
system:
• click the plastic bracket to the right short
side of the rack;
• turn the bracket into the horizontal
position and insert the rack tipped in a
sloping position into the refrigerator;
• place the short side without bracket into
one of the grooves on the left wall of the
refrigerator;
• place the short side with bracket in the
corresponding groove on the right wall of
the refrigerator;
• turn the bracket downwards to fix it into
the groove.
To move a rack, turn the bracket upwards
and remove the rack. Place the rack at the
required height in the way described above.
Securing products for driving
The fitting racks in your refrigerator have a
system for you to secure products while
driving. The system consists of a simple
click-and-slide plastic strip. To secure
products on the rack while driving, push the
plastic strip as tightly as you can against the
products on the rack. In the storage space
on the inside of the refrigerator door, there
are two unique Thetford bottle slides (see
illustration) The slides prevent bottles from
sliding around during driving. Push the slide
against the products in the door or place the
products between the bottle slide .
95
To Next Page
Loading...
Need help?
General
