Swift Vehicle User Manual

Fitted Equipment
TP5000 ELECTRONIC PROGRAMMABLE
ROOM THERMOSTAT
Before programming the thermostat press
the + & - AND and buttons
simultaneously to reset the unit (Fig.1)
Setting the Clock and Day
- Press PROG (Fig.2) to begin programming
- Use + or - buttons (Fig.3) to adjust the
TIME (Fig.4)
- Press PROG again (Fig.2)
- Use + or - buttons (Fig.3) until correct
DAY is shown (Fig.5) (1 = Monday, 2 =
Tuesday, etc)
Accepting the Factory Pre-settings
The TP5000 has pre-set times already
programmed in, which often suit most people
(see Table).
To accept these settings close the front
cover and after 2 minutes the pre-settings
will automatically be accepted.
To adjust the factory pre-settings and set
your own time and temperature
programmes
For Days 1-5 (weekdays)
a) Press PROG (Fig.2) 3 times to show the
1st pre-set time and temperature (Event 1
Days 1,2,3,4,5) (Fig.6)
b) Use + or - buttons (Fig.3) to adjust the
TIME (press and hold to change in 10 min
increments)
c) Use or buttons (Fig.7) to adjust the
TEMPERATURE
d) Press PROG (Fig.2) to move to next
preset time & temp (Event 2) (Fig.8)
e) Repeat steps b, c & d for programming
Events 3,4,5 & 6
For Days 6-7 (weekends)
a) Press PROG (Fig.2) to show 1st pre-set
time and temperature (Event 1 Days 6-7)
(Fig.9)
b) Repeat steps b, c and d above to
programme time and temperature events
for the weekend.
Returning to RUN mode
Press PROG (Fig.2) - the colon in the LCD
display will start to flash (Fig.10)
79
>
>
>
>
Mon-Fri
Event Time Temp °C
1 08.00 20
2 08.30 15
3 11.30 20
4 13.30 15
5 16.30 21
6 22.30 15
Fig 1.
Fig 2.
Fig 3.
Fig 4.
Fig 6.
Fig 5.
Fig 8.
Fig 10.
Fig 9.
Fig 7.
1711 Caravan Owners Hbook 2006 21/7/05 6:04 pm Page 79

Swift Vehicle Specifications

General

Brand	Swift
Model	Vehicle
Category	Motorhomes
Language	English