Electrics
47
Symbol Function Description
Dual Pumps In caravans with an onboard water tank, the pump switch will be a two-way switch with a centre off position.
(AC75 only) This allows the selection of either the internal pump (switch up - Tap symbol) or external pump (switch down -
Water container symbol).
Note: A green indicator lamp will illuminate within the bottom left corner of the battery gauge when the internal
pump motor is running.
Battery This switch is used to display the battery voltage level. Press and hold the switch to display the battery level on
Level Test the gauge.
The green region indicates a battery with a good charge, the yellow region indicates a battery with an adequate
charge, and the red region indicates a battery that requires charging.
Water This switch is used to display the fresh water level within the onboard water tank. Press and hold the switch to
Level Test display the water level on the gauge.
The gauge indicates the water level on an 'Empty - 1/4 - 1/2 - 3/4 - Full' scale, with empty being on the left.
When using the optional remote control unit, please ensure the control panel '12V Power' switch is in the ON position and the
'Entry light' switch is in the OFF position for correct operation of the remote control (as the remote control operates in parallel
with the control panel switches). The remote control button [I] controls the Entry Light and button [II] controls the 12V Power.
If you do not wish to use the remote control, or the remote battery is flat / remote has been lost, you can of course return to
manual operation by using the switches on the control panel. If the power has been turned off using the remote control and
then the remote has been lost / battery become flat you will need to carry out the following to reset the caravan: Place the
Car / Van selector switch on the ESM2004 power supply unit in the centre (OFF) position and turn the charger switch to the OFF
position, wait 5 seconds and then turn the charger and Car / Van selector switch back on.
The UH**** number on the back of the remote control is the remote code number. Please keep a record of this number in case
you need to order a replacement or additional remote control.
To Next Page
Loading...
Need help?
General
