Fitted Equipment
71
2000W (ensure that the fuse protection for
the power supply of the camp site is
sufficient).
If more than 2kw are required (heating
up/cold temperatures) you must refer back
using gas operations as the 230V electrical
operation is a secondary heater only.
The electric heater can also be operated
without the Trumavent fans.
WARNING:-Surfaces become hot in use,
guards provided do not give full
protection to the young or elderly
OPERATING INSTRUCTIONS
Before operating the heater for the first
time it is essential to observe the
operating instructions, enclosed with
the heater.
Control panel with thermostat
a = Rotary switch "Off"
b = Rotary switch "On"
power settings:
500 - 1000 - 2000 W
c = Rotary control knob for room
temperature (illuminated by green
indicator lamp "operation")
Switching On
Attention: Before switching on, ensure that
the fuse protection for the power supply of
the campsite is sufficient for the selected
power setting (b) (see Technical Data).
Important: The electric feed line for the
caravan must be fully unwound from the
cable drum.
1. To switch on, turn the rotary switch to the
desired output level (b).
2. Set rotary control knob (c) to the desired
room temperature.
The thermostat setting on the operating
element (1-9) must be determined individually
depending on the heating requirement and
the type of vehicle. For an average room
temperature of about 23°C, we recommend a
thermostat setting of about 6 -8.
The electric heater can also be operated
without the Trumavent fans.
If the heater is operated simultaneously with
electricity and gas, the electrical unit will
switch itself off before overheating occurs as
a result of the stronger gas burner.
Switching off
Switch the heating system off at the rotary
switch (a).
IMPORTANT OPERATING NOTES
1. Repairs may only be carried out by an
expert.
2. The heater's hot air outlet should under
no circumstances be blocked. Never hang
clothes or similar in front of or on top of
the heater to dry. This could cause serious
damage to the heater as a result of
overheating. Do not place inflammable
materials near the heater! Please observe
these instructions for your own safety.
3. The performance of the room thermostat
will be affected if temporarily covered or
obstructed
4. When operating a brand-new heater for
the first time (or after it has been idle for a
lengthy period) you may temporarily
notice a slight smoke and smell. We
advise running the heater at full power
and thoroughly ventilating the room.
To Next Page
Loading...
Need help?
General
