10. Applicator mat
The applicator mat serves to massage the enre body. Three at pairs of coils with a dierent
number of windings have been integrated in the applicator mat. The upper coil pair at the head
end (cable exit to applicator socket) has the lowest number of windings. The lower coil pair (at
the foot end) has the highest number of windings. Please make sure, that you lie with the head
on the side of the applicator mat, where the cord is coming out of the mat.
The applicator mat can be folded in two places (arrows) (along 1/3 and 2/3 of the length) but
to protect the coils, it cannot be bent or rolled. It is covered by a cushion cover which can be
disinfected and is made of medically approved vinyl (Permaguard®).
NOTE: Please fold like an „S“ and not like an „U“ (Counterfold)!
Care and Cleaning Guide
The vinyl should be cleaned periodically in order to maintain its appearance and prevent build-
up of dirt and contaminants. Any stain, spills or soiling should be cleaned up promptly to prevent
the possibility of permanent staining.
The electro-magnec vibraon does not only work directly above the applicator mat, it expo-
ses in all direcons simultaneously. On the applicator mat, the average peak eld strength is
less than 45 µT (micro Tesla) at the highest intensity level which is approximately equivalent to
the Earth’s magnec eld. According to the preliminary standard DIN 0848, the recommended
upper limit for 24-hours constant use is 400 µT. Horizontally, the vibraon of the magnec eld
in the head area has dissipated at a distance of approximately 3.2/1m and in the foot area at a
distance of approximately 5/1.5m.
This applicaon can only be used with the original applicator mat. If no applicator has been
To Next Page
Loading...