Swiss Bionic Solutions IMRS - Local Application with Applicator Probe; Probe Application for Specific Body Points

Operator‘s Guide / iMRS / Page 29
© Swiss Bionic Soluons Schweiz GmbH / 8834 Schindellegi / 2016
iMRS professional can be individually adjusted between 2 and 60 minutes in one minute steps.
Aer posioning the applicator cushion on the designated area the applicaon is started by
pressing the Start / Stop key (9). The start of the applicaon is signaled by a short melody. The
display (1) indicates the remaining me of the applicaon, the selected applicator and the selec-
ted intensity. The polarity of the electro-magnec vibraon (21) and the organ clock (20) is dis-
played on the info level (24).
A short melody signalizes the end of the applicaon. Aer the applicaon period has nished the
iMRS automacally switches into stand-by mode. Aer remaining in stand-by mode for approx.
2-4 minutes, the iMRS switches o automacally. IMPORTANT: The system cannot be switched
o manually! To completely disconnect the device from the mains, the Plug-In Power Pack must
be removed from the wall outlet.
13.3. Local application using the applicator probe
The applicator probe will be delivered with the iMRS complete and iMRS professional. Connect
the applicator probe to the control unit (13, 14 or 15)). Switch the control unit on using the ON /
OFF switch (4). The device is ready to be used once the inial boot process has been completed
successfully. Choose the applicator probe by pressing the buon (5) on the membrane keyboard.
Certain points of the body can be applied specically using the applicator probe, e.g. joints, trig-
ger points or smaller areas of the body by manually holding the probe over the area.
The standard applicaon duraon of 8 minutes should be selected when applying a electro-
magnec vibraon by “covering” small parts of the body. However you can select the applicaon
period of 8, 16 or 24 minutes with the designated buon (6) on the membrane keyboard.
An appropriate local program is selected automacally. For local applicaons, higher intensity
levels can be used. We recommend that you select lower intensity levels for the head/neck
region of the body (e.g. shoulder = 25 – 50, back = 50 – 100, hips = 100 – 150, thigh = 150 – 200,
calf and foot = 200 , iMRS complete and iMRS professional - 400).
Start the applicaon. The system switches o automacally once the specied applicaon
period is over, the applicaon can also be stopped prematurely at any me using the Start/Stop
key (9). The iMRS professional can be individually adjusted between 2 and 60 minutes in one
minute steps. To completely disconnect the device from the mains, the Plug-In Power Pack must
be removed from the wall outlet.