EN
6
2.0 Scope of Supply
CANopen object description e@syDrive 4624, 4625, 4626 Material no. 2.002.6929
Check that all parts are present.
3.0 CANopen Connection
High speed CAN according to ISO 11898 with a bit rate of 250 kbit/s or a baud rate of 250 kHz.
The CAN interface on the e@syDrive 4624, 4625, 4626 is galvanically isolated. An external 24 V DC power
supply is required. The voltage range is 18…30 V.
A terminating resistance is not included. This terminating resistance (120 Ohm) must be connected
externally in parallel between CAN_H (63) and CAN_L (62). If the resistor is not connected, communication
between the PC and the INV cannot be established.
The maximum input voltage for CAN_H and CAN_L is +16 V DC.
The CAN-ID can be configured via the operating software SycoDrive.
3.1 Connection Example
To Next Page
Loading...