Sylvac UL 4 - Connecting the Instrument; List of the Main Commands

12
13. List of the main commands
Selection and conguration
CHA+ / CHA-
FCT0 ...9...A...F
MM / IN
KEY0 / KEY1
MUL [+/-] xxx.xxxx
PRE [+/-] xxx.xxx
REF1 / REF2 / AREF
STO1 / STO0
TOL1 / TOL0
LCAL dd.mm.yy
NCAL dd.mm.yy
TOL +/-xxx.xxx +/-zzz.zzz
MIN / MAX / DEL / NOR
CLE
UNI1 / UNI0
OUT1 / OUT0
PRE ON / PRE OFF
PRE
SET
NUM xxxxxxxxxx
Change measurement direction
Assign «favourite» function
Change measurement unit
Lock / unlock keypad
Modication of the multiplier
Modify preset value
Change the active reference
Activate/de-activate HOLD
Activate/de-activate tolerances
Modify last calibration date
Modify next calibration date
Inputting tolerance limits
Selecting MIN, MAX, Delta, Normal mode
Re-initialisation of MIN, MAX or Delta mode
Activate/de-activate change of units
Activate/de-activate contin. data transmission
Activate/de-activate preset function
Recall preset
Zero reset
Modify the serial number
12. Connecting the instrument
The instrument can be connected to a
peripheral via a Proximity (RS or USB) or
Bluetooth
®
Smart. (See chap. 1)
Measured values can be transmitted and
the instrument driven using predened re-
tro-commands (see chap. 13 for a list of the
main commands)