11
E
SET
>2s
SET
9. Extinction
The instrument goes automatically into stand-by if not used for 20 minutes,
unless Auto OFF mode has been turned off (see Chap. 4, advanced functions)
Stand-by mode can be forced by a prolonged press (> 2 sec) on
SET
MODE
The initial instrument settings can be restored at any time by a prolonged press
(>4 sec) simultaneously on and until the message rESEt is displayed.
Nevertheless the instrument retains its conguration settings (units and resolution).
In stand-by mode, the value of the origin is retained by the sensor (SIS mode),
and the instrument automatically restarts with any movement of the measure-
ment probe, RS command, Bluetooth
®
request or press of a button.
The instrument can be switched off completely for a long period of non-use,
but this will necessitate a zero reset on restart (the origin will be lost) :
- Prolonged press (>4s) on :
SET
>4s
SET
10. Re-initialising the instrument
11. Personalising the instrument
Access to the functions of your instrument can be personalised, for more infor-
mation see manufacturer’s website (requires you to connect your instrument
via a Proximity RS/USB cable).
Possibilities:
- De-activate or active the required functions
- Modify access to the advanced functions (direct access)
To Next Page
Loading...
Need help?
General
