7
E
4. Advanced functions
MODE
MODE
Prolonged pressure (>2s) on gives access to the advanced functions.
Then, each short press on accesses the required function :
MODE
SET
MODE
SET
MODE
SET
MODE
MINIMUM, MAXIMUM mea-
surement and DELTA (TIR)
.................Tolerance display
(inputting tolerance limits, see chap. 6)
.................Choice of measurement direction
(positive or negative sense)
save the
Preset
3.1 Automatic references
The instrument has the ability to switch automatically between its two references.
This allows using the caliper for both internal and external measuring without
going through the menu to change the reference.
Steps :
On Ref 1
• Introduce a measurement standard as preset, measure this standard and
do a preset recall
• Or set the zero at closed jaws position
On Ref 2
• Measure the internal measurement probes gap (with a caliper, probes
included) and introduce it as preset value
• Do a preset recall at closed jaws position
Set AREF
It is now possible to measure in REF1 when closing the jaws or in REF2 when
opening the jaws.
To Next Page
Loading...
Need help?
General
