Sylvac UL 4 - Construction

13
E
Change measurement direction
Assign «favourite» function
Change measurement unit
Lock / unlock keypad
Modication of the multiplier
Modify preset value
Change the active reference
Activate/de-activate HOLD
Activate/de-activate tolerances
Modify last calibration date
Modify next calibration date
Inputting tolerance limits
Selecting MIN, MAX, Delta, Normal mode
Re-initialisation of MIN, MAX or Delta mode
Activate/de-activate change of units
Activate/de-activate contin. data transmission
Activate/de-activate preset function
Recall preset
Zero reset
Modify the serial number
14. Construction
Hardened steel guide rods
External measurement
Jaw length 200 mm
Jaw width 8 mm
Material TiN coated stainless steel
Internal measurement
Cylindrical measurement probes Ø 8 mm h6
Probe length 30 mm
Material Hard metal
Bluetooth®
BT0/BT1 Activate/de-activate Bluetooth® modules
BTRST Reset pairing information
MAC? Bluetooth® MAC adress ?
Maintenance functions
BAT? Battery status (BAT1=Ok, BAT0=low battery)
OFF Switch off (wake up using a button or RS)
RST Re-initialisation of the instrument
SBY Put instrument in stand-by(SIS)
VER? Version No. and date of rmware
Current value? (mode Tol, value followed by < >)
Measurement sense?
«Favorite» function active?
Measurement unit active?
Keypad locked?
Multiplier value?
Preset value?
Reference active?
Status of HOLD function?
Current tolerance limit values?
Date of last calibration?
Date of next calibration?
Active mode (MIN, MAX, Delta or Normal)?
Main instruments parameters?
Instrument identication code?
Serial number?
Interrogation
?
CHA?
FCT?
UNI?
KEY?
MUL?
PRE?
REF?
STO?
TOL?
LCAL?
NCAL?
MOD?
SET?
ID?
NUM?