10
Engine start control switch
The switch button position is under seat.
“ON” position: Engine is locked and cannot be started engine in this
position.
“OFF” position: When the ignition switch is “on” position, the start
control switch is “off” position, press electrical starter
button while holding the front or rear brake lever will
start the engine.
Horn Switch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to the “ON” position, and slide the turn signal switch to left or right. Then, the turn
signal lights will flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
§STORAGE BOX§
This box is located under the seat.
Maximum load capacity:5kg.
Do not store valuables in the box.
Make sure that the seat has been locked completely after it was
pressed down.
Take out valuables before washing to avoid wetting these objects.
Do not place thermal sensitive objects in the box because of
engine’s heat and high temperature.
§SAFETY HELMET HOOK§
Stop the motorcycle, and hook the safety helmet chin belt
the hook.
To Next Page
Loading...
Need help?
General
