Sym GTS 250 - Brake Light Switch;Starting Inhibitor; Switch; Headlight Beam Distance; Wheel; Tire

2. Maintenance Information
2-13
Brake Light Switch/Starting Inhibitor
Switch
The brake lamp switch is to light up brake lamp as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.
Headlight Beam Distance
Turn on main switch
Headlight beam adjustment. Turn the headlight
adjustment screw to adjust headlight beam high.
Caution
 To adjust the headlight beam follows related
regulations.
 Improper headlight beam adjustment will make
in coming driver dazzled or insufficient
lighting.
Wheel / Tire
Caution
● Tire pressure check should be done as cold
engine.。
Appointed tire pressure
Tire size
Front tire
Rear tire
Tire pressure as
cold engine
(Kg/cm²)
Load for
under 90 Kg
1.75
2.25
Full loaded
1.75
2.50
Check if tire surface is ticked with nails, stones or
other materials.
Check if front and rear tires’ pressure is in normal.
Measure tire thread depth from tire central
surface.
Replace the tire if the depth is not come with
following specification
Front tire：1.5 mm
Rear tire：2.0 mm
Stop switch
Headlight beam adjustment screws
To this chapter contents