Sym MAXSYM 400 - Page 18

18
If the smart key indicator goes on in red when pushing the answer back button, it shows the battery is
discharged, follow the below steps to replace the battery:
 Wrap a coin or a flat head screwdriver that covered with a protective cloth, and insert into the slit ○A
and carefully remove the upper case ○B .
 Remove the inner cover ○A and replace the old battery with a new one; face the positive terminal side
up.
Battery type
CR2032
 Reverse the above steps to install, make sure the ring ○B is correctly mounted and do not damage the
rubber seal ○C .
Declaration of Conformity
This smart key system complies with the Radio Equipment Directive (2014/53/EU).
NOTE :
 Do not touch the chips or the circuit board to avoid problems.
 If you lack proper experience or doubt your ability, have the battery changed by your authorized SYM
dealer.
○A
○B
○A
○B
○C