To Next Page

To Previous Page

Right Handlebar Switches

○A Engine Stop Switch

This switch should normally remain in the position for the scooter to operate. In an emergency, switch

to the position to stop the engine.

○B Starter Button

This starter button operates the electric starter when the engine is not running. Turn the ignition switch on;

push this button while holding the front or rear brake lever to start the engine.

Left Handlebar Switches

○A Passing Light Button

When pushing the passing light button , the high beam indicator goes on to signal the driver of the

vehicle ahead that you are about to pass. The passing light is shut off as soon as the button is released.

NOTE :

 Even though the engine stop switch can stop the engine, it does not turn off all the electrical circuits.

Normally the engine stop switch should be used to stop the engine.

NOTE :

 This scooter is equipped with a permanently lit headlight; the position light, tail light, and the license plate

light will light up once the ignition switch is turned on. The headlight will light up when the engine is

started. The above mentioned lights cannot be turned off.

 Do not leave the scooter behind too much time after turning the ignition switch on.

○A

○B

○A

○B

○C

○D

○E

○F

Questions and Answers:

Need help?

Do you have a question about the Sym MAXSYM 400 and is the answer not in the manual?

Sym MAXSYM 400 Specifications

General