To Next Page

To Previous Page

1. General Information

1-5

 Lubricate the rotation face with specified

lubricant on the lubrication points before

assembling.

 Check if positions and operation for installed

parts is in correct and properly.

 Make sure service safety each other when

conducting by two persons.

 Note that do not let parts fall down.

 Before battery removal operation, it has to

remove the battery negative (-) cable firstly.

Notre tools like open-end wrench do not contact

with body to prevent from circuit short and

create spark.

 After service completed, make sure all

connection points is secured.

Battery positive (+) cable should be connected

firstly.

 And the two posts of battery have to be greased

after connected the cables.

 Make sure that the battery post caps are

located in properly after the battery posts had

been serviced.

 If fuse burned, it has to find out the cause and

solved it. And then replace with specified

capacity fuse.

Capacity

verification

To this chapter contents

Questions and Answers:

Need help?

Do you have a question about the Sym MAXSYM 400i and is the answer not in the manual?

Sym MAXSYM 400i Specifications

General