To Next Page

To Previous Page

14. Brake System

14-11

Master Cylinder Install

Install the rubber pad into the groove correctly.

Place the master cylinder onto handlebar, and

install the bolts.

Install the brake lever, and connect leads to brake

light switch.

Connect brake hoses with 2 new washers.

Tighten the brake hose bolt to the specified torque

value.

Make sure the hose is installed correctly.

Install all wires, hoses, and components carefully

to avoid twisting them together.

Caution

Improper routing may damage leads, hoses or

pipes.

Caution

Kink of brake leads, hose or pipe may reduce

brake performance.

Add specified brake fluid and bleed the system.

To this chapter contents

Washers

Brake light

switch

Brake hose

2 bolts

Questions and Answers:

Need help?

Do you have a question about the Sym MAXSYM 400i and is the answer not in the manual?

Sym MAXSYM 400i Specifications

General