Sym MAXSYM 400i - Page 35

2. Maintenance Information
2-12
Brake Light Switch / Start Switch
The brake light switch is to light up brake lamp as
brake applied.
Make sure that starter motor can be operated only
under brake applying.
Wheel / Tire
Caution
 Tire pressure check should be done as cold
engine.。
Appointed tire pressure
Tire size
Front tire
Rear tire
Tire pressure as
cold engine
(Kg/cm²)
Load for
under 90 Kg
2.00
2.25
Full loaded
2.00
2.50
Check if tire surface is stuck with nails, stones or
other materials.
Check if front and rear tires’ pressure is in normal.
Measure tire thread depth from tire central
surface.
Replace the tire if the depth is not come with
following specification
Front tire：1.5 mm
Rear tire：2.0 mm
Stop switch
To this chapter contents