36
Coolant Level Inspection / Filling
This scooter is filled with high quality coolant that is designed for the cooling system in the factory. It contains
a 50% solution of ethylene glycol based antifreeze. Position the scooter on level ground and in an upright
position. The coolant inspection window ○A can be seen on the right side of the under spoiler. The coolant
level must be between the “F” ○a and “L” ○b marks. Top up the coolant carefully when the level is at the “L”
mark.
Pull up the tip of the right front floor panel mat ○A and remove the maintenance cap ○B from its tip.
Open the reserve tank cap ○A to fill in coolant.
Reverse the above steps to restore.
NOTE :
You can add soft water to the coolant reserve tank in an emergency, it must be restored to the correct
mixture ratio afterwards.
If you have to add coolant often, the cooling system may have a leakage problem, have your scooter
checked by an authorized SYM dealer.
WARNING:
Never remove the radiator cap when the engine is hot.
To Next Page
Loading...
