DOC 6511_Release K
ATS-6511A/B/C Users Guide
9
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:slots:N command (N=Slot #) to obtain
the current settings for a particular card.
ATS-6511> settings hardware:slots:1
[tsc4373]
[ports]
[1]
[pps_period] 1
[pps_width] 1.000000000000000e-04
[type] pps
[2]
[pps_period] 1.000000000000000e-06
[pps_width] 5.000000000000000e-07
[type] pps
[3]
[format] A
[signal_word] 3
[type] irig
[4]
[format] B
[signal_word] 0
[type] irig
[OK] 2010-05-27T16:40:11Z
Note: The system will drop the leading Zeros in the signal_word.
To verify the card is working properly use the status hardware:outputs:slots:N command (N=Slot
#) to obtain the current settings for a particular card.
ATS-6511>status hardware:outputs:slots:1
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4394A
[OK] 2013-08-13T14:27:55Z
2.4.2.2 4395A-10 / 4395B-10 (10MHz)
No programming is required for these modules. These modules will also work in any of the 6
card slots. To verify these cards are working properly use the status hardware:outputs:slots:N
command (N = slot number) to obtain the current status for a particular card.
ATS-6501>status hardware:outputs:slots:3
[ports]
[1]
To Next Page
Loading...
Need help?
General
