DOC 6511_Release K
ATS-6511A/B/C Users Guide
47
3. Inspect the connectors. Verify that the cable connectors are not damaged at the
connection to the ATS-6511, upstream 4372A/4372A-T (ATS-6501) or TSC-4340 (1U
1x8 Fiber Distribution Amplifier.
5.3 Fan Filter
The fan filters helps protect the system from accumulating dust inside the unit as well and allows
the fans to provide the proper level of cooling for the internal components. It is important to keep
this filter clean to allow the proper level of air flow to prevent the system from overheating. To
clean the filter:
1. Remove the fan assembly from the front by loosening the two captive screws.
2. Remove the filter from the fan assembly.
3. Use a vacuum cleaner to clean the fan filter of any accumulated dust.
4. Re-install the filter and assembly into the chassis. Take care to feed the cable into the
chassis while inserting the fan assembly.
To Next Page
Loading...
Need help?
General
