DOC 6511_Release K
ATS-6511A/B/C Users Guide
66
Appendix B Status Command Fields
This section provides information on the results from the status command.
ATS-6511B>status
[alarm] no alarm Highest priority alarm.
[fiber] Fiber Information
[chassis_delay] -3.000000000000000e-10 Chassis Calibration Value
[clock_offset] 9.497872340000000e-09 Current Clock offset from the source
[da4340delay] 0.000000000000000e+00 Fiber Dist Amp Delays
[fpga]
[delay] 0.000000000000000e+00 Internal Delays
[inputA] good Input A Status
[inputB] good Input B Status
[steer] -1.000000000100000e-12 Clock Steer value
[two_way] Two Way Data Exchange Information
[channelA] Fiber A
[4340_output] 0 0 = no 4340, # = 4340 Channel
[clock_offset] 1.000000001111078e-10 Current Fiber offset.
[direct_connect] true True = no 4340 in the path.
[fiber_delay] Measured fiber delays
[local] 6.887777777811110e-08 Fiber length in nSec.
[remote] 6.335555555555556e-08 Fiber length reported by 6501.
[remote_tdc_time] 2011-11-07-18:07:55 Time measurement was made.
[rxdelay] -3.690000000000000e-08 Factory Calibration values
[txdelay] -3.690000000000000e-08
[channelB] Fiber B (same as A)
[4340_output] 0
[clock_offset] -6.601419878215690e-09
[direct_connect] true
[fiber_delay]
[local] 5.368593644378431e-08
[remote] 7.398039215686274e-08
[remote_tdc_time] 2011-11-07-18:07:57
[rxdelay] -3.650000000000000e-08
[txdelay] -3.650000000000000e-08
[hardware] System Information
[fan] Fan Status
[1] true Fan 1
[2] true Fan 2
[mainboard] Unit Information
[EUID] 00:a0:69:00:03:00:00:f8 Main Board Electronic ID
[serialnum] 164233 Unit S/N
[type] 6511 Model #
[outputs] Outputs
[enabled] true On=Enabled, Off=Disabled
[slots] Output Card Information
[1] Slot #
[ports] Port Information
[1] Port #
[status] good Port Status
[2]
[status] good
[3]
[status] good
[4]
To Next Page
Loading...
Need help?
General
