DOC 6511_Release K
ATS-6511A/B/C Users Guide
55
To check the status of the output card use the status hardware:outputs:slots:N command (N=Card
Slot #) to verify the card status.
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4387A
6.2.8 NASA36 Outputs
The ATS-6511 is capable of providing NASA 36 Time Code outputs on each port of the 4387A
AM IRIG card. The 4387A outputs are set to IRIG B120 by default. Users can modify these
settings. Users are cautioned to ensure they connect the correct cables to the correct output ports
to avoid any problems.
To verify the settings use the settings hardware:slots:N command (N=Card Slot #) to verify the
system settings.
ATS-6511>settings hardware:slots:5
[tsc4387]
[ports]
[1]
[format] B
[signal_word] 120
[type] irig
[2]
[format] B
[signal_word] 120
[type] irig
[3]
[format] B
[signal_word] 120
[type] nasa36
[4]
[format] B
[signal_word] 120
[type] irig
To check the status of the output card use the status hardware:outputs:slots:N command (N=Card
Slot # of the 4387A) to verify the card status.
ATS-6511> status hardware:outputs:slots:5
[ports]
[1]
[status] good
[2]